IEC60061-3 G13 go gauge and not o gauge 7006-45-4 7006-44-4

Purpose:

To check dimensions E max., F min., F max., and the combined pin diameter and displacement of pins (including bosses) of bi-pin caps G13 on finished lamps.

Testing:

The pins of the caps on finished lamps shall enter the gauge at surface O and, when fully inserted, the surfaces of cap and gauge shall contact.

In this position the end of the pins shall be co-planar with or project beyond surface X, but shall not project beyond surface Y.

Each individual pin shall enter hole e₁ at surface O until the face of the cap and the surface of the gauge contact.

Category of G13 Gauges:

7006-44-4: "Go" & "Not Go" Gauge for unmounted BI-PIN cap

7006-45-4: "Go" Gauge for BI-PIN cap on finished lamp