IEC60061-3 E27 lamp gauge
“GO” GAUGE FOR E27 CAPS ON FINISHED LAMPS, Cód. 7006-27B-1

."NOT GO" GAUGE FOR E27 CAPS ON FINISHED LAMPS, Cód. 7006-28A-1

.GAUGE FOR FINISHED LAMPS FITTED WITH E27 CAPS FOR TESTING CONTACT-MAKING, Cód. 7006-50-1

GAUGE FOR CAPS ON FINISHED LAMPS FOR TESTING PROTECTION AGAINST ACCIDENTAL CONTACT DURING INSERTION E27, Cód. 7006-51A-2

GAUGE FOR CAPS ON FINISHED LAMPS FOR TESTING PROTECTION AGAINST ACCIDENTAL CONTACT E27/51X39, Cód. 7006-51-2

 

PURPOSE:

To check the maximum dimensions of the screw thread and dimension T1 minimum of caps on finished lamps shown on sheet 7004-2.

TESTING:

When the cap on a finished lamp has been screwed into the gauges as far as it will go, the centre contact shall be co-planar with, or project beyond surface X.